| English. | Japanese. |
|
|
Yesterday's access. |
| Introduction. | [Lily Diary.】 A diary of life in Mindanao. |
| 25/07/13 | IARU HF Contest  |
| 25/07/10 | Software updates |
| 25/07/08 | DXV500ZS linear amplifier repair |
| 25/07/07 | CQ Machine Program |
| 25/06/21 | LoTW system upgrade |
| 25/06/18 | RG8 for 3.5MHz arrived |
| 25/06/15 | Time setting Ver0.5 |
| 25/06/14 | Drone Habsan ZINO arrives |
| 25/06/12 | Philippine Independence Day |
| 25/06/11 | Algeria 7X2RF QSL card. |
| 25/06/10 | Translation API Program |
| 25/06/09 | DXCC150 award certificate arrived |
| 25/06/08 | AutoCWType_Ver1.4.1 |
| 25/06/07 | Introducing the Shack |
| 25/06/06 | A portrait drawn by ChatGPT. |
| 25/05/26 | Windows full-width/half-width switching. |
| 25/05/17 | OK2ZAW BCD to 16 converter. |
| 25/05/16 | For 3.5MHz Zepp antenna. Stepping motors |
| 25/05/15 | 3.5MHz stepping motor design. |
| 25/05/14 | 3.5MHz tuning coil installed. |
| 25/05/11 | 3.5MHz antenna installation completed. |
| 25/05/03 | JTDX Autonomous Driving Program Ver0.4.3. |
| 25/04/26 | Drone Habsan ZINO. |
| 25/04/25 | Time setting Ver0.3. |
| 25/04/24 | AutoCWType_Ver1.3. |
| 25/04/23 | Preparing for FTDX3000 LCD repair. |
| 25/04/22 | Installation plan for 3.5MHz Zepp antenna. |
| 25/04/21 | AutoCWType_Ver1.1. |
| 25/04/20 | 10,14MHz antenna installation completed. |
| 25/04/19 | JTDX Autonomous Driving Program Ver0.4.1. |
| 25/04/19 | 14MHz antenna pole installed. |
| 25/04/18 | ThinkPad X390 repair completed. |
| 25/04/17 | Search is now possible. |
| 25/04/15 | Preparing the 10MHz dipole. |
| 25/04/12 | Hexbeam Part8. |
| 25/04/06 | My ThinkPad X390 is broken. |
| 25/04/05. | Time setting program. |
| 25/03/31 | JTDX Autonomous Driving Program. |
| 25/03/30 | Automatic log sending from CWType to Hamlog. |
| 25/03/21 | Hexbeam Part 7. |
| 25/03/20 | FreeDV Part 3 First QSO. |
| 25/03/18 | FreeDV Part 2 QSO in the shack. |
| 25/03/16 | Hexbeam Part 6. |
| 25/03/15 | Install FreeDV Part1. |
| 25/03/09 | Hexbeam Part5. |
| 25/03/07 | Hexbeam Part 4. |
| 25/03/05 | 28MHz antenna modification |
| 25/03/01 | FTDX3000 is broken! |
| 25/02/28 | Pileup at 50MHz FT8. |
| 25/02/28 | DXV500ZS linear amplifier repair. |
| 25/02/27 | Tower pipe rebuilding plan. |
| 25/02/26 | Direction to Japan from Ozamiz. |
| 25/02/26 | 28MHz is not available. |
| 25/02/23 | DXV500ZS linear amplifier repair. |
| 25/02/22 | Hexbeam Part 3 |
| 25/02/21 | Hexbeam Part 2 |
| 25/02/18 | 28MHz antenna construction. |
| 25/02/17 | 18,24MHz antenna height construction. |
| 25/02/16 | Z26NS Cosovo. |
| 25/02/14 | 21MHz FT8 |
| 25/02/12 | 7,21MHz antenna repair. |
| 25/02/08 | Operating CW at 21MHz. |
| 25/02/05 | DXV500ZS linear amplifier failure. |
| 25/01/19 | Input Director. |
| 25/01/14 | Temporary license renewal. |
| Hexbeam Part5 (2025/03/09) | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Until now.Hexbeammouth turned down at the cornerslink 24/10/14 Hexbeam Purchase Plan 25/02/21 Hexbeam Part2 25/02/22 Hexbeam Part3 25/03/07 Hexbeam Part4 25/03/09 Hexbeam Part5 25/06/16 Hexbeam Part6 25/03/21 Hexbeam Part7 25/04/12 Hexbeam Part8 |
||||||||||||
| We made the power feed and center post for Hexbeam. The blueprints arehttps://www.hex-beam.com/center-post-2/I used what I had in
|
||||||||||||
| It's a water pipe, and over here it's called a blue pipe. Marking and drilling holes  |
||||||||||||
| Drilling of 12 holes for 6 bands completed Holes are drilled at a 90-degree angle because it is impossible to insert bolts if holes are drilled in a 180-degree arrangement.  |
||||||||||||
| Installation of stainless steel bolts 6 mm in diameter and 20 mm in length The information said to use hard wire, but I couldn't get it. So it is temporarily attached to the end of a wooden stick with vinyl tape After temporarily fixing the bolt, pull the stick and the tape will come off.  |
||||||||||||
| Coaxial cable in the power feed It was recommended to use RG8X, but Ozamiz could not get it, so I used RG8.  |
||||||||||||
It was difficult to process the thick and hard RG8 coaxial, but we were able to finish processing and installing 5 terminals. |
||||||||||||
The desk top looks awesome! |
||||||||||||
Completion of center post |
||||||||||||
Liquid Electrical Tape It is instructed to apply Liquid Electrical Tape to prevent deterioration of the coaxial characteristics due to moisture I went to three electrical supply stores in Ozamiz, but they did not carry it, so I ordered it through mail order in the Philippines.  |
||||||||||||
| March 07, 2025 Mar. 15, 2025 | ||||||||||||
